Recmar® Head Gasket Set Volvo Penta KAD42 KAD43 TAMD41 3583787 876104 3583786 Jetzt Bestellen

High-quality marine engine spare parts.

Recmar® decarbonizing gasket set for Volvo Penta:

• AD41A, AD41B, AD41D, AD41L-A, AD41P-A
• AQAD41A, AQD41A
• D41A, D41B, D41D, D41L-A
• TAMD41A, TAMD41B, TAMD41D, TAMD41H-A, TAMD41L-A, TAMD41M-A, TAMD41P-A
• TMD41A, TMD41B, TMD41D, TMD41L-A
• KAD42A, KAD42B, KAD42P-A
• KAMD42A, KAMD42B, KAMD42P-A
• TAMD42B, TAMD42WJ-A
• KAD43P, KAD43P-A, KAMD43P, KAMD43P-A

This head gasket kit, also known as a decarbonizing gasket kit, includes the head gasket with reference  3583786, 3582433, 3580742, 858992, 876853. The cylinder head bolts with reference 838775 should be replaced when needed[1], and tightening should be performed in five stages, following the attached diagram. 

Tightening torque settings:

• 30 Nm
• 60 Nm
• 100 Nm
• Angle-tighten the screws 90° in numerical order as follows: Mark up the position of the screw heads with a chalk mark on the screw and cylinder head. Do not use a punch or a scribe as they can confuse future operations. Mark a 14mm socket, locate the socket as illustrated on the second picture, with the socket marking 90°counter-clockwise from the chalk mark on the cylinder head. Carry out angle tightening by tightening until the socket mark and the cylinder head chalk-mark are opposite each other.
• Angle-tighten the screws 90° in numerical order as above. Tightening is finished when all screws have been angle tightened to 90°. Retightening after use is not necessary.